Home > Moped Brand > Honda >

Indigan Honda Hobbit Ignition Adapter Plate
Indigan Honda Hobbit Ignition Adapter Plate


 
Alternative Views:


Price: $29.99

Stock Status:(Out of Stock)


Availability:: Usually Ships in 24 Hours
Qty:

Description
 
Hondas have a few options when it comes to ignition. This neat adapter plate allows you to run any Puch, or Puch sized ignition you want! Points, CDI, Power Dynamo, the world is your oyster.

Notice the bolt position on the plate in the pics, they can be configured to hold larger Bosch stators in place, or smaller HPI. Tons of room for experimenting here. If you do run the larger Bosch flywheel, it looks like you may need to trim a bit on the case to get it in there. Not much though.

Made in Kalamazoo Michigan, and includes all the hardware you see here.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Finally, So many options! February 10, 2017
Reviewer: Shane Rickert from Kalamazoo, MI United States  
Perfect for swapping that puch HPI onto your hobbit!  If you are going to use an ignition with a larger flywheel, not everything fits, so you may have to open them up or sand down the edge.  5 minutes with a belt sander and you could put anything on there.  It probably fits more stator plates than it needs to, maybe even non-puch ones?  It will accept 90mm and 94mm diameter stators, so start mixing and matching ignition parts, because there is a whole new word of possibilities!

Was this review helpful to you?