Return to Pedal Arm Pin 9mm
Sort By::
Page of 2
Previous   


  0 of 0 people found the following review helpful:
 
5 of 5 It does what its supposed to June 3, 2016
Reviewer: Anthony B from Canyon Country, CA United States  
Used these on a italian pacer toptank. I had to shave a little bit more off the angle on the pins to have it fit deeper into the pedal slots. Not sure what theyre cut to fit for, but shaving off a bit of the material, it now fits.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 9mm cotters May 23, 2016
Reviewer: Andrew 40 from Prescott, Arizona US  
Got these for the mustard pedal arms,the powder coat is a hair to thick,I used some sand paper wrapped around chop stick and boom slipped right in

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 Run a little large January 16, 2016
Reviewer: Vincent Mota from San Juan Capistrano, CA United States  
I ordered a couple of these and none of them would fit in the pedal arm as is. It only took a minute with a file to remove enough material to make it work though, they were just hair too wide.

Was this review helpful to you?

   
  Previous