Home > Moped Parts > Engine > Intake Manifolds >

Puch Maxi Magnum 19mm Intake Manifold
Puch Maxi Magnum 19mm Intake Manifold

Price: $16.00

Stock Status:In Stock

Puch intake manifold for all your Puch kits that need a bigger manifold.  Great for Dellorto PHBG carbs.

Use a coupler, or just clamp on with the right Shim.  OD is 24mm

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 Puch intake manifold June 24, 2016
Reviewer: James Kataoka from Mililani, HI United States  
Although the manifold is said to install 19 mm Dellorato carb; it needs a little work. I shortened the carb snout by 6 mm and cut off the same amount on the manifold and it became a very close fit. They connected well with a short hose and clamps. I ordered 4 ea. gaskets to raise the manifold a bit. I think the crankcase most likely need not be ground to clear the carb while it's mounted perfectly square. I bought the Puch with the 65 cc Metra on it and the 19 mm carb. I am 85 years old, the bike is too fast for me, it's scary. I think I'll trade it for a slower 4 stroker. Aloha from Hawaii.  James.

Was this review helpful to you?